Pengaruh  Diameter Pipa Primer  Pada  Irigasi Tetes Bertingkat

I Dewa Gede Jaya  Negara; Hartana Hartana; Anid  Supriyadi; Yusron  Saadi; I Wayan  Yasa; Ryan Bagus  Julio

doi:10.29303/jstl.v10i1.573

Authors

I Dewa Gede Jaya Negara Jurusan Teknik Sipil, Fakultas Teknik Universitas Mataram
Hartana Hartana Jurusan Teknik Sipil, Fakultas Teknik Universitas Mataram
Anid Supriyadi Jurusan Teknik Sipil, Fakultas Teknik Universitas Mataram
Yusron Saadi Jurusan Teknik Sipil, Fakultas Teknik Universitas Mataram
I Wayan Yasa Jurusan Teknik Sipil, Fakultas Teknik Universitas Mataram
Ryan Bagus Julio Jurusan Teknik Sipil, Fakultas Teknik Universitas Mataram

DOI:

https://doi.org/10.29303/jstl.v10i1.573

Keywords:

Distribution, Discharge, Uniformity, Variation

Abstract

Multilevel drip irrigation is an irrigation method that supports water-saving agricultural activities in limited areas by channeling water through perforated pipes from emitters. An ideal multilevel drip irrigation system can provide the same volume of droplets to plants, so that the distribution of irrigation water and the uniformity of drip irrigation are important factors that need to be considered when using drip irrigation to provide plant irrigation. This research aims to determine the effect of using variations in the diameter of PVC pipes as primary pipes on the distribution of drip irrigation and its uniformity. The primary irrigation network tested for each network to the 1st floor to the 3rd floor consists of ½", ¾" diameter and 1" pipe, while the secondary and lateral drip pipe networks use ½" PVC. The test was carried out on an area of 4 m x 1 m x 1.8 m with a distance between levels of around 0.9 m, with an irrigation water source from a 200 liter tank placed on a tower with a height of 2.5 m.The results of the research show that the discharge produced by the main pipe is different on each floor of the irrigation network, on the 1st floor the discharge is 127.13 cm3/second and on the 3rd floor the discharge is 120.91 cm3/second, while on the 2nd floor the discharge is between the values of the 1st floor discharge. and 3rd floor. Regarding the results of the distribution of drip irrigation water volume, it is known that the average does not show significant differences due to differences in network operations or due to differences in pipe diameters used, where the values for floors 1 to 3 are respectively 68.75 ml, 68 .47ml, 68.19ml. The uniformity of drip irrigation shows results above 94% on all network floors and is considered very good.

References

Hamzanwadi, R. (2015). Pengaruh Variasi Kemiringan dan Waktu Penetesan Terhadap Keseragaman Tetesan Pada Sistem Irigasi Tetes, Mataram.

Meijer, T.K.E. (1989). Sprinkler and Trickler Irrigation. Wageningen, The Netherlands: Departement of irrigation and Civil Engineering, Wageningen Agriculture University.

Negara, I. D. G. J., Heri, S., Supriyadi, A., Yasa, I. W., Putra, I. B. (2022). Karakteritik Distribusi Volume Irigasi dan Debit Aliran Irigasi Aktual Setiap Sistem Jaringan Irigasi Tetes pada Lahan Layanan Bertingkat. Jurnal Ganec Swara Vol. 16, No.1, Maret 2022. ISSN 1978-0125 (Print); ISSN 2615-8116 (Online).

Negara, I. D. G. J., Saidah, H., Yasa, I. W., Hanifah, L., Dewi, D. P. (2022). Analisis Kemampuan Sistem Irigasi Tetes Bertingkat Dalam Pemberian Lengas Tanah Pada Polybag. Jurnal Ganec Swara Vol. 16, No. 2, September 2022. ISSN 1978-0125 (Print); ISSN 2615-8116 (Online).

Negara, I. D. G. J., Saadi, Y., & Putra, I. B. G. (2014). Analisis Sistem Irigasi Tetes Terpadu Pada Lahan Kering Pringgabaya Kabupaten Lombok Timur. Spektrum Sipil, ISSN 1858-4896. Vol. 1, No. 1: 73-80, Maret 2014.

Prabowo, A & Hendriadi, A. (2004). Pengelolaan Irigasi Hemat Air di Lahan Kering Aplikasi Irigasi Tetes dan Curah, Banten.

Rahayu, P., Putri, Rosalina., & Indriyani, N. (2021). Pengaruh Diameter Pipa Pada Aliran Fluida Terhadap Nilai Head Loss. Jurnal Agitasi Vol. 2, No. 1 (2021).

Rai, I. B. (2010). Analisis Pemberian Air Sistem Irigasi Tetes Di Daerah Lahan Kering Akar – Akar Kabupaten Lombok Utara, Mataram.

Suparman, Tri Andini Ariesta., (2015). Analisa Pengaruh Perbedaan Ketinggian Tandon Terhadap Debit Dan Keseragaman Tetesan Pada Pipa Dalam Rangkaian Sistem Irigasi Tetes, Mataram.

Taufiqurrahman, M., (2016). Pengaruh Variasi Diameter Dan Jarak Antar Lubang Penetes Terhadap Keseragaman Tetesan Pada Sistem Irigasi Tetes, Mataram.

Triatmodjo, Bambang, 2003. Hidraulika II. Beta Offset. Yogyakarta.